LV6 Navigation Systems Test Panel
(DAI Part# LV6)
The LinAire LV6 Navigation systems Test Panel is engineered to operate
and provide aids in the testing of VOR, VOR/LOC, VOR/ILS/MKR receivers
and their multiple systems components, including their indicators and
control heads. All of these can be tested as part of a system and most
can be tested alone. A system can be operated using it's components
while providing the ability, via tip jacks, metering, etc..., to monitor or
check all key functions of the unit under test. The system provides for
testing several different ways, including user developed tests.
The LV6 operates and aids in the testing of VOR/LOC, GS, MKR
receivers systems including their indicators and control heads. All
of these can be tested as part of a system and most can be tested alone.
A system can be operated using it's components while providing the
ability, via tip jacks, metering, etc..., to monitor or check all key functions
of the unit under test. The system provides for testing several different
ways, including user developed tests. Parallel frequency control is
accomplished using LinAire LVC control heads. Serial frequency and
function control is accomplished using adapter plates that mount in
the LVC control head location. This gives the option of using system
controls or to use the system controller as well as monitor the operation
of the controller using the many LV6 test jacks. Course Selectors may
be connected to the panel by several different methods: rear cabinet
connector, front connector or via panel tip jacks. Compass and bearing
signals from an external source are connected via a rear mounted
connector and are switched by the LV6 controls.
The panel has a connector for the utilization of LA series NAV and NAV/
COM harnesses allowing panel mounted NAV receivers to be serviced
at the Nav Bench. (Audio and Power connections ONLY.) LinAire has a
full line of new panel mounted Nav, Nav/Com harness (LV 6100 series
and LVI) that take advantage of all the test and monitoring facilities
of the LV6.
The following list the panel functions and controls:
Metering
3 1/2 digit panel meter measures the following:
DC Volts, DC AMPS, AC Volts (26 and 115), AC AMPS, Audio RMS
Volts (600 ohm load), Nav Deviation, Nav Flag, GS Deviation, GS Flag
and To-FROM (200 ohm load).
Navigation Section
Frequency Control: Parallel (UUT freq. controller or LVC head), Serial
(Unit Under Test freq. control head or Simulator) Panel does not come
with a control head, must be purchased separately. Deviation: Metering
and 1 to 5 selectable 1K ohm loads. FLAG: Metering and 1 to 5 selectable
1K ohm loads. SUPER FLAG: Indicator lamp and Test Jack. COMPASS
(X, Y, Z) and BEARING (X', Y', Z') Source Selections 65 Breakout Jacks
for monitoring test points
Glide Slope Section
Deviation: Metering and 1 to 5 selectable 1K ohm loads
Flag: Metering and 1 to 5 selectable 1K ohm loads
Super Flag: Indicator Lamp and Test Jack
ILS Engage switch
Marker Section
Outer, Middle, and Airway lamps with Test Jacks
High/Low Sense switch
Marker Audio output to panel speaker or headphones
Panel Size and Finish
The LV6 panel is 7 inches high, 19 inches wide, 5.25 inches deep.
The panel finish is an epoxy based LinAire Tan with Dark Brown
Lettering with knobs of Brown and Gold.
|
|